Installation And Configuration - Samoa 383 750 Manual Del Usuario

INSTALLATION AND CONFIGURATION

The description below contains an explanation about the
device configuration, the end of line resistor and the
screen display mode.
For more details about the installation and configuration,
check out the "installer's guide" of the management system.
ELECTRICAL WIRING
WARNING: Disconnect the power source before
servicing or repairing electrical equipment.
DATA AND POWER BUS CONNECTION
1. Strip the end of the CAN-Bus cable (381 954) (fig. 4).
2. Connect each wire of the CAN-Bus cable to the
provided 5 pole male plug (951 880) (fig. 5).
Depending on installation layout, it may not be necessary
to plug both CAN-Bus connectors.
PULSE METER WIRING
Follow the next procedure:
1. Open the device and pass the pulse meter cable
through one of the cable glands (1).
2. Make the connection according to the type of pulse meter:
2a. One channel pulse meter:
Connect both wires of the pulse meter to terminals
"A" (2) and "COM" (3) of the U·count electronic
board.
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
2 3
37 mm
10
1
Ø4 self-tapping screw
CAN 1
SV 1
SV2
PULSER
CAN 2
R. 06/18 838 849
EN
7
fig. 4
fig. 5
3