Operating Principle; Assembly - Blumfeldt Korinth Manual Del Usuario

Operating principle

This solar pump is designed primarily to operate in sunlight hours and always
charge extra energy to battery to allow use later "on demand" in cloudy day
or night time. The pump will turn to solar mode automatically on next day in
sunlight hours. The pump will never run on battery mode until your press the
button.

ASSEMBLY

1 Take out all parts of the packaging. Please keep in mind that some water
may splash over the rim of a bowl, do not set up the cascade fountain on a
surface which may be damaged by water.
2 Open the door behind the fountain.
3 Fill the cascade fountain with clean tap water.
4 Connect the pump to the tube and place the pump underwater and make
sure that, it is fully immersed in water..
5 Connect the pump cable to the socket of the control housing on the rear
side of the solar panel;
6 Connect the LED light cable to the socket of the control housing.
7 Close the door behind the fountain. Make sure direct sunlight shines on
the solar module.
8 The solar cascade fountain is now ready for use.
EN
13