Filling Fuel; Setting The Time - Qlima SRE0031TC Instrucciones De Uso

2. Open the lid of the tank compartment  and remove the piece of cardboard.
3. Fill the removable tank as indicated in Section B.
4. The floor should be firm and completely level. Reposition the heater, when it is not level. Do not try to
correct the situation by placing books or other goods under the heater.
5. Use the horizontal safety bracket  to prevent the curtains from covering the ventilator (Fig. B.).
6. Insert the plug  into the wall-socket (230 Volts - AC / 50 Hz) and set the correct time using the adjustment
keys  (refer to Section C).
7. Your heater is now ready for use.
B

FILLING FUEL

Fill the removable tank in a suitable place since there can always be some spillage. Follow the procedure below:
1. Make sure that the heater is switched off.
2. Open the upper lid and lift the removable tank out of the heater (Fig. C). Note: Some drops may leak from the
tank. Put down the removable tank (cap pointing upwards, handle on floor and take off the fuel cap.
3. Remove the metal cap (unscrew). Easy to open by holding the outside (fig. D.).
4. Fill the removable tank using a fuel pump (refer to fuel pump operation instructions.) Make sure that it is in a
higher position than the removable tank (Fig. E). Insert the ribbed hose into the opening of the removable tank.
5. Check the removable tank fuel gauge while filling the tank (Fig. F). Stop filling once the gauge indicates that the
tank is full. Never overfill the tank, especially not when the fuel is very cold (fuel expands when it heats up).
6. Let the remaining fuel in the pump flow back into the jerrycan and carefully remove the pump. Carefully
reposition the fuel cap back on the tank. Clean off any spilled fuel.
7. Check whether the fuel cap is straight and tightened properly. Reinstall the removable tank in the heater (cap
down). Close the lid.
G
• Do not move the heater after reinstalling the tank.
• Take care not to damage the cap while filling the tank. Deformation of the cap can lead to fuel
leakage.
8. Turn the heater on again.
C

SETTING THE TIME

Set the time to use the heater as a clock or if using the timer. You can even set the time when the heater is on.
1. Press the mode key  to set the time (fig. G). Time set and the time flash on the display.
2. Press the buttons (▼) or (▲)
to go forwards and the (▼) button to go backwards. The time will change in one minute steps each time you press
one of these 2 buttons. The time on the display will change in ten minute steps if you keep the button pressed (fig.
H.).
3. Press the mode key  again to activate the timer function. See chapter F.
4. Press the mode key  to display the time (fig. I.). If the time is not set, the display indicates --:--.
The time must be set again after a power cut or if the plug has been removed from the socket.
D
IGNITING THE HEATER
When used for the first time, a new heater may give out a smell for a short while. You should therefore provide
extra ventilation.
G
Always ignite the heater with the ON / OFF button
1. Press the ON / OFF button
temperature are displayed (fig. J.). The ambient temperature is displayed from 1ºC. If the temperature is below
0ºC, Lo is displayed. Ignition takes about 45 seconds.
4
26
to set the time. The time displays the numbers 00:00 to 23:59. Press the (▲) button
19 19
. The ignition indicator will light up: the required temperature and the ambient
20 20
. Never use matches or a cigarette lighter.
20 20