Publicidad
Idiomas disponibles
Idiomas disponibles
Description
The model Pro220K™ Advanced Tone and Probe kit is designed to find
and identify wires and their terminating point. It consists of the Pro110™
Tone Generator, the Pro210F™ Advanced Tone Probe, and the Pro21™
Carrying Case.
Features on the Pro110™ Tone Generator include;
Features on the Pro210F™ Advanced Tone Probe include;
Battery Installation
The models Pro110™ Tone Generator and Pro210F™ Advanced Tone
Probe each require four AA (LR6) batteries (not included). Remove the
battery compartment cover on the back of each unit and install, being
careful to match the correct polarity of the battery and the units. If the
batteries have been installed correctly and turned on, LEDs will light.
Operation – Tone Generator
WARNING - Never connect to live wires greater than 60 volts
including 110 or 220 volt AC service.
Connect the model Pro110™ Tone Generator to the wire you wish to
trace using one of the red or black alligator clips and leads. When using
the clips, you may either connect to a single wire of a pair with each clip
that run together or 1 clip to a wire and one to earth ground. Results
vary with each method so experiment. You can connect to a wall jack
using the RJ11 modular adapter.
Pro220K™ Operating Instructions
Tone Transmit Indicator LED
AA Battery Powering
Heavy Duty Strain Relief
Short Circuit LED with Audible Alarm
Heavy Duty, Water-resistant Case
Loop for Hook or Lanyard Hanging
RJ11 Modular Plug
Bright LED Headlight
Wrist Strap
Headset Jack
AC interference Rejection
Volume Control
2
Publicidad
