Nostalgia Vintage Collection CCP900 Instrucciones Y Recetas página 9

Assembly of Base Support
1. Attach Handle (E) onto the Storage Compartment (C) using four #1 Screws.
2. Insert Front Cross Beam (J) between the Foot Stand (I) and secure with two #4 Bolts.
3. Insert the Rear Cross Beam (K) between the ends of the Foot Stand (I). Attach the
Wheel (G) to the Rear Cross Beam (K) and the Foot Stand (I) with one Axle Bolt (F)
and one #5 Flat Washer on the outside of the wheel, then one #6 Flat Washer and
one Rubber Mat (N). Repeat on the other side with the second Wheel (G).
#6 Flat
Washer
#5 Flat
Washer
Axle Bolt (F)
7
Rear Cross
Beam (K)
Rubber
Mat (N)
Wheel (G)
#4 Bolt