Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
•
Beyond replacing batteries and fuses, do not attempt to repair or service your Meter unless you
are qualified to do so and have the relevant calibration, performance test, and service
instructions. The recommended calibration cycle is 12 months.
•
Periodically wipe the case with a damp cloth and mild detergent.
Do not use abrasives or solvents.
•
Dirt or moisture in the terminals can affect readings.
•
To clean the terminals:
a) Switch the Meter OFF and remove the test leads.
b) Shake out any dirt that may be in the terminals.
c) Soak a new swab with isopropyl alcohol and work around the inside of each input terminal.
d) Use a new swab to apply a light coat of fine machine oil to the inside of each terminal.
TEST LEADS REPLACEMENT
Warning: Full in compliance with safety standards can be guaranteed only if used with test leads
supplied. If necessary, they must be replaced with the same model or same electric ratings. Electric
ratings of the test leads: 600V/10A. You must replace the test leads if the lead is exposed.
•
The measurement category of a combination of the test leads and an accessory is the lower of
the measurement categories of the test leads and of the accessory.
•
The test leads intended for use within measurement category I, shall not to use the test leads for
measurements within the other measurement categories.
TESTING THE FUSES
Warning: To avoid electric shock or injury, remove the test leads and any input signals before
replacing the fuses.
1. Turn the rotary switch to 200mA position.
2. Use a multimeter to measure resistance of VΩmA terminal or 10A terminal to COM terminal.
a) A good mA terminal or 10A terminal fuse is indicated by a reading between 0Ω and 10Ω.
b) If the display is overloaded, replace the fuse and test again.
c) If the display shows any other value, have the meter serviced.
3. Please replace fuse as below:
Fuse1: F10A / 600VH
Fuse2: F0.5A / 600VH
ENVIRONMENTAL PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories
and packaging should be sorted, taken to a recycling centre and disposed of in a manner
which is compatible with the environment.
DISPOSAL
Do not dispose battery in household waste.
Batteries should be disposed of in a responsible manner, they must be disposed at
appropriate collection point.
Dispose of this product at the end of its working life in compliance with the EU Directive
on Waste Electrical and Electronic Equipment. Contact your local solid waste authority
for recycling information or give the product for disposal to BGS technic KG or to an
electrical appliances retailer.
SW-Stahl und Werkzeugvertriebs GmbH
5
d i e
6
e
s
s
a r t S
h
c
s
m
e
R
Tel. +49 (0) 2191 / 46438-0
r e
F
ax +49 (0) 2191 / 46438-40
s
u
k r e
v
e
7
9
8
2
4 -
D
e
L
d . l h
a t s
w
s
@
o f n i
: l i
Publicidad
Tabla de contenido
