Environmental Protection - BGS technic 63402 Manual De Instrucciones

Replacement of battery and fuse
Under normal conditions, it is unnecessary to replace the fuse. Don't replace it until the probes are
unplugged and the power is shut down. Take out the two screws of the rear cover to remove the
housing!
Warning
To avoid electric shock make sure the probes are disconnected
from the measured circuit before removing the rear cover.
Make sure the rear cover is tightly screwed before using the
instrument.
Don't put the instrument into use until the rear cover is screwed
after replacing battery or fuse.
The specification of the fuse is: F1 250mA / 600V and F2 10A /
600V. The replacement should be of the same specification.
The battery for this multimeter is 9V NEDA 1604 / 1604A, IEC
6F22 / 6LR61. The replacement should be of the same
specification.
Attachments
Instruction Manual
One pair of probe
9V battery NEDA 1604 / 1604A, IEC 6F22 / 6LR61

ENVIRONMENTAL PROTECTION

Recycle unwanted materials instead of disposing of them as waste. All tools, accessories
and packaging should be sorted, taken to a recycling centre and disposed of in a manner
which is compatible with the environment.
DISPOSAL
Do not dispose battery in household waste.
Batteries should be disposed of in a responsible manner, they must be disposed at
appropriate collection point.
Dispose of this product at the end of its working life in compliance with the EU Directive
on Waste Electrical and Electronic Equipment. Contact your local solid waste authority
for recycling information or give the product for disposal to BGS technic KG or to an
electrical appliances retailer.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed