Removing The Battery Pack; Checking The Remaining Battery Power; Initial Setup - Sony PDW-HD1500 Manual De Instrucciones

4
Connect the DC cable of the BKP-L551 to the DC IN
12V connector.

Removing the battery pack

With the lever pushed in, slide the BP-GL95 out as shown
below.

Checking the remaining battery power

You can use the LEDs on the side panel of the battery to
check the remaining power of the battery.

Initial Setup

This unit is shipped with the area of use (PDW-HD1500/
F1600 only), system frequency, recording format, and
current date and time still unset.
Therefore, you need to make initial setup settings before
using the unit. (You cannot use the unit without setting it
up.)
Once the unit has been set up, the settings are retained even
when the unit is powered off.
Use the following procedures.
Lever
1
2
3
POWER
1
ACCESS
CH-1 CH-3
ALL CH
CH-2 CH-4
CHAPTER
EXPAND
VARIABLE KEY INHI
REC PAGE
NET ON
PRE-
LOCAL
SET
OFF
REMOTE
PB HOME
PHONES LEVEL PREV PLAY NEXT STOP REC
DISPLAY
SHIFT
TOP F REV F FWD END STANDBY REC INHI
5,6
Power the unit on.
The INITIAL SETUP screen appears on the display.
Turn the PUSH SET(S.SEL) knob to select the area of
use (PDW-HD1500/F1600 only).
Display UC (for regions outside Japan) or J (for
Japan), and then press the SET function button (F5).
The system frequency screen appears.
Turn the PUSH SET(S.SEL) knob to select the system
frequency.
EJECT
MARK1
PUSH SET(S.SEL)
IN OUT
MENU
MARK2
SHTL/JOG
VAR/JOG
RESET
RETURN
THUMBNAIL
SUB CLIP
DISC MENU
2,3,4 5
Preparations
21