General Power Tool Safety Warnings; Work Area Safety; Electrical Safety; Personal Safety - DeWalt DCF813 Manual Del Usuario


Denotes risk of fire.
EC-Declaration of Conformity
Machinery Directive
10.8 V Cordless Impact Wrench
DCF813
10.8 V Cordless Impact Driver
DCF815
D WALT declares that these products described under
e
Technical Data are in compliance with:
2006/42/EC, EN60745-1:2009+A11:2010, EN60745-2-2:2010.
These products also comply with Directive 2014/30/EU and
2011/65/EU. For more information, please contact D
the following address or refer to the back of the manual.
The undersigned is responsible for compilation of the technical
file and makes this declaration on behalf of D
Markus Rompel
Director Engineering
D WALT, Richard-Klinger-Straße 11,
e
D-65510, Idstein, Germany
20.04.2016
WARNING: To reduce the risk of injury, read the
instruction manual.

General Power Tool Safety Warnings


WARNING: Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
SAVE ALL WARNINGS AND INSTRUCTIONS
FOR FUTURE REFERENCE
The term "power tool" in the warnings refers to your mains-
operated (corded) power tool or battery-operated (cordless)
power tool.

1) Work area safety

a ) Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
b ) Do not operate power tools in explosive
atmospheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks which
may ignite the dust or fumes.
c ) Keep children and bystanders away while operating
a power tool. Distractions can cause you to lose control.

2) Electrical safety

a ) Power tool plugs must match the outlet. Never
b ) Avoid body contact with earthed or grounded
c ) Do not expose power tools to rain or wet conditions.
d ) Do not abuse the cord. Never use the cord for
WALT at
e
e ) When operating a power tool outdoors, use an
WALT.
e
f ) If operating a power tool in a damp location is

3) Personal safety

a ) Stay alert, watch what you are doing and use
b ) Use personal protective equipment. Always wear
c ) Prevent unintentional starting. Ensure the switch
d ) Remove any adjusting key or wrench before turning
e ) Do not overreach. Keep proper footing and balance
f ) Dress properly. Do not wear loose clothing or
g ) If devices are provided for the connection of dust
modify the plug in any way. Do not use any adapter
plugs with earthed (grounded) power tools.
Unmodified plugs and matching outlets will reduce risk of
electric shock.
surfaces such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric shock if
your body is earthed or grounded.
Water entering a power tool will increase the risk of
electric shock.
carrying, pulling or unplugging the power tool. Keep
cord away from heat, oil, sharp edges or moving
parts. Damaged or entangled cords increase the risk of
electric shock.
extension cord suitable for outdoor use. Use of a cord
suitable for outdoor use reduces the risk of electric shock.
unavoidable, use a residual current device (RCD)
protected supply. Use of an RCD reduces the risk of
electric shock.
common sense when operating a power tool. Do not
use a power tool while you are tired or under the
influence of drugs, alcohol or medication. A moment
of inattention while operating power tools may result in
serious personal injury.
eye protection. Protective equipment such as dust mask,
non-skid safety shoes, hard hat, or hearing protection used
for appropriate conditions will reduce personal injuries.
is in the off position before connecting to power
source and/or battery pack, picking up or carrying
the tool. Carrying power tools with your finger on the
switch or energising power tools that have the switch on
invites accidents.
the power tool on. A wrench or a key left attached
to a rotating part of the power tool may result in
personal injury.
at all times. This enables better control of the power tool
in unexpected situations.
jewellery. Keep your hair, clothing and gloves away
from moving parts. Loose clothes, jewellery or long hair
can be caught in moving parts.
extraction and collection facilities, ensure these are
EnGLIsh
23