Eaton Powerware 5125 Guia De Instalacion página 24

INSTALLATION
1.
NOTE The redundant power source must be protected with Transient Voltage Surge
Suppression (TVSS).
2.
10
EATON Powerware
Mains
Figure 9. Connecting One PDU (Non-Redundant) to UPS
UPS
1
Mains
Figure 10. Connecting Two PDUs (Dual-Redundant) to UPS
If you are installing a UPS and non-redundant power to the device(s)
is desired, plug the PDU power cord into the UPS output receptacle
(see Figure 9) using the supplied power cord.
If you are installing a UPS and dual-redundant power to the
device(s) is desired, two PDUs are required. Plug the first PDU
power cord into the UPS output receptacle (see Figure 10) using
the supplied power cord. Then plug the second (redundant) PDU
power cord into a non-UPS protected output receptacle (mains) or
into a second UPS.
Insert the supplied cord retention clips by each output receptacle
that will be used (see Figure 11).
®
5125 (9910-P33) UPS Installation Guide for IBM
PDU
UPS
2
1
PDU PDU
2
® S
Applications 164201634 Rev A
TVSS Protected or
Second UPS
3
Mains