Final Installation Checklist; Operation Checklist - GE P2S930YPFS Instrucciones De Instalación

8
INSTALL AND CHECK
ANTI-TIP DEVICE
WARNING
Never completely
remove the leveling leg as the range will not
be secured to the anti-tip device properly.
Follow instructions supplied with ANTI-TIP
bracket.
9
LEVEL THE RANGE
WARNING
Never completely
remove the leveling leg as the range will not
be secured to the anti-tip device properly.
A. Plug in the unit.
B. Measure the height of your countertop at the
rear of the opening (X).
C. Adjust two rear leveling legs so that the rear
of cooktop is at the same height or higher
than the counter (Y).
D. Slide unit into place.
E. Install oven shelves in the oven and position
the range where it will be installed.
F. Check for levelness by placing a spirit
level on one of the oven shelves. Take two
readings—with the level placed diagonally
first in one direction and then the other.
G. Adjust front leveling legs until the range is
level.
H. Look under the unit and verify that the rear
leg is fully engaged with the anti-tip device. If
not, remove the unit and adjust the height of
the rear leg so that it is properly engaged.
Anti-Tip Bracket
Kit Included
X
Y
Cooktop
0" or Greater
Counter
NOTE: Cooktop must be at or above counter.
Spirit level
10

FINAL INSTALLATION CHECKLIST

• Check to make sure the circuit breaker is closed (RESET) or the circuit fuses are replaced.
• Be sure power is in service to the building.
• Check that all packing materials and tape have been removed. This will include tape on metal
panel under control knobs (if applicable), adhesive tape, wire ties, cardboard and protective
plastic. Failure to remove these materials could result in damage to the appliance once the
appliance has been turned on and surfaces have heated.
• Check that the door and drawer are parallel to each other and that both operate smoothly. If they
do not, see the Owner's Manual for proper replacement.
• Check to make sure that the rear leveling leg is fully inserted into the Anti-Tip bracket and that the
bracket is securely installed.

OPERATION CHECKLIST

• Check that the oven control operates properly. If the oven control does not operate properly,
recheck the wiring connections.
• Be sure all range controls are in the OFF position before leaving the range.
INSTALLATION INSTRUCTION
31-2000834 Rev. 0 09-20 GEA
P2S930