Makita BUB142 Manual De Instrucciones página 4

Switch action
CAUTION:
Before inserting the battery cartridge into the tool,
•
always check to see that the switch trigger
actuates properly and returns to the "OFF" position
when released.
3
008313
To start the tool, simply pull the switch trigger. Tool
speed is increased by increasing pressure on the switch
trigger. Release the switch trigger to stop.
Air volume adjusting dial
Air volume can be adjusted to any of three settings by
turning the adjusting dial with the switch trigger fully
depressed. Refer to the table below for the relationship
between the number on the dial and the air volume.
Number on the dial
3
2
1
008312
CAUTION:
Use the adjusting dial only after the switch trigger
•
returns to the "OFF" position. Turning the dial
before the trigger returns may damage the tool.
If the tool is operated continuously until the battery
•
cartridge has discharged, rest the tool for at least
15 minutes before proceeding with a fresh battery.
ASSEMBLY
Blowing
For dust blowing, attach nozzle to blower outlet, turning
clockwise to lock it in place.
1
008310
1. Pointer
1
2. Air volume
adjusting dial
3. Switch trigger
2
Air volume
High
Medium
Low
1. Nozzle
2
2. Blower outlet
Dust suction
1
3
4
008311
For dust suction, fit nozzle onto suction inlet and dust
bag onto blower outlet.
After the bag fills with dust, empty the contents of the
dust bag into a dust bin by releasing the fastener.
007170
CAUTION:
Empty the dust bag before it becomes too full, or
•
the suction force weakens.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.
Cleaning
From time to time, wipe off the outside of the tool using a
cloth dampened in soapy water. Never use gasoline,
thinner or the like, or discoloration and/or cracks can
take place.
008314
4
1. Dust bag
2
2. Blower outlet
3. Suction inlet
4. Nozzle
1. Fastener
1