Uline H-1347 Guia De Inicio Rapido página 2

3. Mark the four holes on the wall where screws will be
inserted. (See Figure 3)
Figure 3
Recommended Mounting Locations
1. Insert key into lock opening on top of dispenser and
turn to open cover. (See Figure 5)
Figure 5
2. Insert a roll on each arm and close lid. (See Figure 6)
NOTE: The access panel on the bottom of the
dispenser must be on the right side.
Figure 6
PAGE 2 OF 6
MOUNTING INSTRUCTIONS CONTINUED
LOADING INSTRUCTIONS
1-800-295-5510
4. Drill into wall at four marked locations with 1/4" drill
bit. Insert wall anchors if necessary. (See Figure 4)
Figure 4
5. Hold dispenser over previously drilled holes and
insert screws.
3. When first roll is out, slide access panel to the left to
begin using second roll. (See Figure 7)
NOTE: The roll on the left side must be used up
before the roll on the right can be used.
Figure 7
uline.com
0821 IH-1347