Instructions; Safety Instructions; General Safety Instructions - Testboy Profi III LED+ Manual De Instrucciones

Instructions

Safety instructions

General safety instructions

Observe the five safety rules:
1.
2.
3.
4.
5.
®
Testboy Profi III LED+
WARNING
Sources of danger are, e.g. mechanical parts, which can cause serious injury to per-
sons.
There is also a risk to objects (e.g. damage to the device).
WARNING
An electric shock can result in death or serious injury to persons, and also impair the
function of the objects (e.g. damage to the device).
WARNING
Never point the laser beam towards the eyes through reflective surfaces, directly or in-
directly. Laser radiation can cause irreparable damage to the eyes. The laser beam
must be deactivated when measuring close to people.
WARNING
For reasons of safety and approval (CE) arbitrary conversion and/or modification to the
device are not permitted. In order to ensure safe and reliable operation using the de-
vice, always observe the safety instructions, warnings and the information contained in
the section "Intended use".
WARNING
Before using the device observe the following instructions:
| Do not operate the instrument near electrical welding devices, induction heaters or
other electromagnetic fields.
After abrupt temperature changes, the device must be allowed to adjust to the new
|
ambient temperature for approx. 30 minutes before using it, in order to stabilise the
IR sensor.
| Do not expose the device to high temperatures for a extended periods of time.
| Avoid dusty and humid environments.
Measuring instruments and their accessories are not toys, and must be kept out of
|
the reach of children!
In industrial facilities, observe the accident prevention regulations for electrical
|
installations and equipment, established by the employer's liability insurance
association.
Disconnect
Ensure that the instrument cannot be switched on again
Ensure isolation from the power supply (check that there is no voltage at both poles)
Earth and short-circuit
Cover adjacent live parts
Instructions
11