Schumacher Electric SWI-1224 Manual Para El Propietario página 42

10.3 Assemble the Wheels and Axle
Then, using a hammer, tap one of the axle caps onto the top end of the axle. Be sure
to tap the axle cap on straight. Slide both wheels onto the axle with the recessed hubs
facing out as shown. Install the second axle cap.
10.4 Mount the Axle to the Charger
bottom of the charger. Place the axle assembly under each bracket. Attach the brackets
using the two, 10-32 thread cutting screws provided.
NOTE: Be careful not to drop the brackets inside of the charger case.
: Hold the axle upright on the floor or work surface.
: Place one end of each bracket into the slot on the
• 38 •