Loading The Nailer - Makita AN610H Manual De Instrucciones

Loading the nailer

CAUTION:
• Make sure that the coil support plate is set to the
correct step for used nails.
► 1. Magazine cap 2. Latch lever 3. Door
Disconnect the air hose from the tool. Select nails suit-
able for your work. Depress the latch lever and open the
door and magazine cap.
Lift and turn the coil support plate so that the arrow with
nail size indicated on the coil support plate will point to
the corresponding graduation increment marked on the
magazine. If the tool is operated with the coil support
plate set to the wrong step, poor nail feed or malfunc-
tion of the tool may result.
3
► 1. Adjustfit 2. Change plate 3. Arrow
Place the nail coil over the coil support plate. Uncoil
enough nails to reach the feed claw. Place the first nail
in the driver channel and the second nail in the feed
claw. Place other uncoiled nails on feeder body. Close
the magazine cap slowry until it lock after checking to
see that the nail coil is set properly in the magazine.
1
2
3
1
2
6 ENGLISH
1
2
► 1. Door 2. Nail guide 3. Feeder
Connecting air hose
Slip the air socket of the air hose onto the air fitting on
the nailer. Be sure that the air socket locks firmly into
position when installed onto the air fitting. A hose cou-
pling must be installed on or near the tool in such a way
that the pressure reservoir will discharge at the time the
air supply coupling is disconnected.
OPERATION
CAUTION:
• Make sure all safety systems are in working
order before operation.
1. To drive a nail, you may place the contact element
against the workpiece and pull the trigger, or
(1)
► 1. Trigger 2. Contact element
3
1
2