Makita AN610H Manual De Instrucciones página 7

(2)
► 1. Trigger 2. Contact element
2. Pull the trigger first and then place the contact
element against the workpiece.
• No. (1) method is for intermittent nailing, when you
wish to drive a nail carefully and very accurately.
No. (2) method is for continuous nailing.
CAUTION:
• However when the tool is set to the "Intermittent
Nailing" mode, WITH THE TRIGGER HELD IN
A HALF-PULLED POSITION, an unexpected
nailing could occur, if contact element is allowed
to re-contact against the workpiece or the other
surface under the influence of recoil.
In order to avoid this unexpected nailing, per-
form as follows;
— A. Do not place the contact element against the
workpiece with excessive force.
— B. Pull the trigger fully and hold it on for 1-2 sec-
onds after nailing.
• For No. (1) method, set the change lever to
the position.
For No. (2) method, set the change lever to
the position.
After using the change lever to change the nailing
method, always make sure that the change lever
is properly set to the position for the desired nail-
ing method.
► 1. Change lever 2. Trigger
1
2
► 1. Change lever 2. Trigger
Nailing of steel plate
WARNING:
• Use 2.3 mm (3/32") or les steel for C-shaped one.
The tool will bounce severely and a nail struck
back, causing serious injuries.
• Use hardened nails only for steel plate.
Using other purposed nails may cause serious injuries.
• When nailing, hold the tool so that it stands
upright to the driving surface.
Slanted nailing may cause nails to strike back,
causing serious injuries.
• When fastening a corrugated zinc plate on the
C-shaped steel, use 0.7 mm (1/32") or less thick
plate and 32 mm (1-1/4") long hardened nails.
Failure to do so may cause nails to strike back,
causing serious injuries.
• Do not use the tool for nailing on ceiling or roof.
Choose and use nails more than 10 mm (3/8") longer
than total thickness of all workpiece to be fastened by
referring to the table below.
Material thickness
1.8-22(5/64"-7/8")
10-27(3/8"-1-1/16")
15-30(19/32"-1-3/16")
15-38(19/32"-1-1/2")
1
2
► 1. 0.7 mm (1/32") or less thick for a zinc plate
2. Thickness of workpiece 3. 10 mm (3/8") or more
4. C-shaped steel (Thickness 1.6 mm (1/16") - 2.3
mm (3/32"))
7 ENGLISH
(mm)
4
1
2
Nail length
(mm)
32(1-1/4")
38(1-1/2")
45(1-25/32")
50(2")
1
2
3