Publicidad
Enlaces rápidos
The device under test is manufactured by the grantee, Lamson & Sessions. Per 47 CFR
2.909, 2.927, 2.931, 2.1033, 15.15(b) etc..., the grantee must ensure the end-user has all
applicable / appropriate operating instructions.
INFORMATION TO BE INCLUDED IN THE USER'S MANUAL
The following information will be included in the user's manual to ensure continued
FCC and Industry Canada regulatory compliance. The ID numbers will be included
in the manual if the device label is not readily visible to the end user at the time of
sale.
************************************************************************
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
WARNING: Changes or modifications not expressively approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This Class B digital apparatus complies with Canadian ICES-003.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help."
************************************************************************
Re:
Certification for Lamson & Sessions Transmitter
Model/PN(s): 3301T
FCC ID: DE4-3301T
IC: 2998A-3301T
FCC ID: DE4-3301T
IC: 2998A-3301T
Publicidad
Manuales relacionados para Carlon RC3302
Resumen de contenidos para Carlon RC3302
- Página 1 Certification for Lamson & Sessions Transmitter Model/PN(s): 3301T FCC ID: DE4-3301T IC: 2998A-3301T The device under test is manufactured by the grantee, Lamson & Sessions. Per 47 CFR 2.909, 2.927, 2.931, 2.1033, 15.15(b) etc…, the grantee must ensure the end-user has all applicable / appropriate operating instructions.
- Página 2 Note: Your new wireless chime button can only be used to add of in fire. To continue changing melody or tone or a button to an existing Carlon Wireless Chime system. It can not 3. Replace old battery(s) with new selection, press down once again and melody be used with any other mechanical or wireless chime system.
- Página 3 1. Use a nail clipper or wire cutter to cut where purchased for replacement OR send the product and the ALSO AVAILABLE FROM CARLON: and separate one of the wires ("A" dated sales receipt to: •...