Remote Control; Before First Use - mamibot EXVAC660 PLATINUM Manual De Instrucciones

Remote control

1. ON/OFF button
2. Display screen
3. Home
4. Automatic mode
5. ON/STOP button
6. Directional buttons
7. Suction power button (TURBO)
8. TIME SETTING
9. 30 minutes mode / single room
10. Mopping mode
11. Plan button
12. Edge cleaning path mode
Warning:
If the vacuum robot is near the docking station and a virtual safety wall, it is possible that it will not recognise the
instructions issued by the remote control If you do not use the remote control for a long time, remove the batteries.

BEFORE FIRST USE

1. Insert the batteries into the remote control.
2. Apply the cleaning brushes as indicated by R and L.
3. Connect the charging base to an electrical outlet using the AC adapter. Place the charging base against the
wall and remove obstacles about 1 meter at two sides and 2 meters forward. The indicator light must light
up when connecting to a mains power supply. It is recommended to fix the charging base to the floor, e.g.
by double-side mounting tape. Place the power supply cable so to avoid tangling of the vacuum cleaner.
4. Place the vacuum robot onto the charging base.
5. The vacuum robot battery will start charging automatically. Allow the battery to charge for more than
12 hours before first use. The charging status flashes on the display during charging, it stops flashing after
the battery is fully charged. If the battery is near the discharge point, the vacuum cleaner will automatically
search for the charging base.
6. Before using the vacuum robot, please remove any objects from the floor that can prevent the vacuum
robot from operating (cables, chairs, small items, inappropriately placed carpet, etc.)
4
5
7
10
11
1 m
1 m
2 m
EN
1
2
3
6
8
9
12
87