Function - SATA 500 Instrucciones De Servicio

Operating Instructions SATA filter 500
4. Check that the bayonet of the filter housings has engaged (Caution!
Filter housings are only correctly fitted after an audible "click"!)
5. Slowly open upstream shut-off tap (not included in delivery)
6. Turn regulating cap [1-8] clockwise until required pressure is dis-
played in the pressure gauge [1-6].
7. Check pressure when operating the spray gun (trigger fully pulled)
and re-adjust if necessary.
9.

Function

9.1. Filter stage [A]:
The first filtering stage separates particles > 5 µ as well as condensed wa-
ter and oil. A sinter filter (Art. No. 22160) is integrated in the filter.
Notice!
Sintered filter:
• Fineness 5µm
If a certain condensate level is exceeded, the automatic condensate drain
valve [1-10] opens under pressure. Apart from a small residual quantity,
the condensate is drained through the condensate drain hose [1-14] into
the container (not included in delivery).
9.2. Filter stage [B]:
The fine filter cartridge (Art. No. 1097999) in the second filter stage
separates smallest particles together with aerosols.
Notice!
Fine filter cartridge:
• Special micro fibre fleece
• Fineness 0.01 µm, separation degree 99.998 % related to a particle
size > 0.01 µm
9.3. Filter stage [C]:
The activated charcoal cartridge (Art. No. 1098004) in the third filter
stage absorbs aerosols. Filter stages [A] and [B] must always be fitted
upstream from an activated charcoal filter.
EN
79