Specified Conditions Of Use; Residual Risk; Mains Connection - Gude GWS 400 HM-2 Traducción Del Manual Original

ENGLISH
26
The operating personnel must have received
sufficient training in use, setup and maintenance.

Specified Conditions of Use

To be used outdoors only. The circular saw for
firewood is used for cross cutting of firewood. It is
necessary to follow all technical specifications and
safety instructions.
Pieces of wood that are too short, too light or too thin
to get caught by the barbs in the feed cradle must not
be processed by the machine.
The machine may only be used if it is fully
assembled.
Operation of a machine that is not fully assembled
is strictly prohibited.
The machine may only be operated by one
person.
Make sure there is nobody present in the
dangerous area. The minimum distance is 2 m.

Residual Risk

Risk of injury
In spite of compliance with all relevant design
regulations, dangers may still present themselves
when the machine is operated, e.g.:
• Risk of injury to fingers and hands. Never put your
hands in the saw blade area.
• Parts of workpieces and tools fly off from damaged
tools. Wear eye protectors.
• Noise emission: It is necessary to wear ear
protectors.
• Wood dust emission: Wear a respirator.
Despite the observance of the operating instructions
there still may be some hidden residual risks.
Residual risks may be minimised by following the
safety instructions and use as designated provisions
and the Operating Instructions.
The exposure to dust is influenced by the type of the
material processed. It is important to use local exhaust
(catching near the source) and adjust well the exhaust
covers, guide elements and the grab channels.
Dust produced during work is often harmful and must
not get in your body. Use the exhauster and wear an
appropriate respirator, too. Remove thoroughly any
deposited dust, e.g. by vacuuming.
Use saw blades designed to reduce emitted noise.
Keep the machine and saw blade running.
To minimise noise production, the tool must be
sharpened and all elements for noise minimisation
(covers, etc.) must be properly adjusted.
Emergency procedure
Conduct a first-aid procedure adequate to the injury
and summon qualified medical attendance as quickly
as possible. Protect the injured person from further
harm and calm them down. If you seek help, state the
following pieces of information
1. Accident site
2. Accident type
3. Number of injured persons
4. Injury type(s)

Mains Connection

Operation is only allowed with a safety switch
against stray current (RCD max. stray current of
30mA).
Before putting into operation, a qualified electrician
must check whether electric safety measures required
are in place. Any national regulations in this regard
must be complied with.
Electric connection to a socket.
It is necessary to make sure the connecting socket
was not near water and humidity and the plug was
protected against humidity. Check the voltage.
Technical data given on the type label must
correspond with electric network voltage.
Only use splash proof extension cables approved for
outdoor purposes.
Check the cable and/or socket for damages before the
appliance putting into operation. In case damage let
repaired in authorized workshop
To avoid danger, a damaged mains supply pipe must
be replaced by the manufacturer. Do not under any
circumstances attempt any repair yourself.
Cable connections to be separated by pulling the plug
only. Pulling the cable could damage both the cable
and plug. As a result, electric safety would no longer
be guaranteed.
Symbols
Caution! Warning!
Caution!
Read the operating instructions to reduce
the risk of injury.
Caution!
Unplug the machine before any servicing
or repair!
Always wear goggles when using the
machine.