How To Use - JB Systems Light LED PIPE Manual De Instrucciones

ENGLISH

HOW TO USE:

MENU STRUCTURE:
JB SYSTEMS
®
OPERATION MANUAL
3/26 LED PIPE CONTROLLER
ENGLISH
INSTALLATION STEPS:
To be sure that the LED PIPE system works properly you must follow the steps below every time
you change the number of tubes, put tubes at different locations or simply disconnect and
reconnect one or more tubes:
 INSTALL ALL TUBES: Refer to the installation manual included with each LED PIPE RGB 230V for
proper installation.
 INSTALL THE CONTROLLER:
Put the controller in a suitable place.
o
Connect the supplied DC adapter to the controller.
o
o Connect the signal output to the signal input of first LED PIPE.
 TEST CONNECTIONS: we will test the connection between the controller and the LED PIPES.
Connect the mains to the first LED PIPE. All the LED PIPES will start working in automatic
o
mode.
Switch the controller on
o
Press the MENU button until the display shows "ReSet Mode".
o
o Press the ENTER button: display shows "ReSet?". Use the UP/DOWN buttons to change
the blinking "NO" to "YES" and press ENTER to confirm.
When the display shows "ReSetting OK!", all the connected LED PIPES should turn white.
o
This indicates that the controller is well connected.
 SET THE NUMBER OF LED PIPES MANUALLY: To be able to produce nice programs, the
controller needs to know how many LED PIPES are connected.
o Use the MENU button to select "1. SystemSet" and press the ENTER button.
The display shows "1.1 Tube Amount"  press ENTER, the current amount starts blinking.
o
Use the up and down buttons to set the exact number of connected tubes.
o
Press the ENTER button to confirm
o
Press the MENU button twice to go back in the main menu.
o
Remark: If the number of connected tubes doesn't match the number set on the controller, the
system will not work properly. Some tubes will even not work at all!
 DMX512 ADDRESSING:
Use the MENU button to select "1. SystemSet" and press the ENTER button.
o
Press the UP and DOWN buttons to select "1.2 DMX512 Addr" and press ENTER.
o
The current DMX-address starts blinking.
o
Use the UP and DOWN buttons to set the new DMX-address and press ENTER to confirm.
o
o Press the MENU button twice to go back in the main menu.
STANDALONE MODE:
This is the simplest way to operate the LED PIPE system.
Use the MENU, ENTER and UP/DOWN buttons to select the desired mode or patterns from the list that
you see in the MENUSTRUCTURE. There are 4 modes, each with 8 different patterns:
Auto mode: 8 automatic patterns (speed to be selected, not music controlled)
o
When a pattern is selected you still have to select the desired speed (speed is blinking).
o
Confirm your choice by pressing ENTER.
For some patterns you also have to choose in which direction the pattern should run 
o
(current direction is flashing) choose "left" or "right" and confirm with ENTER.
Sound mode: 8 music activated patterns
o
For some patterns you have to choose in which direction the pattern should run 
o
(current direction is flashing) choose "left" or "right" and confirm with ENTER.
dB mode: 8 music activated "VU meter-like" patterns
o
o When a pattern is selected you still have to select the desired speed (speed is blinking).
Confirm your choice by pressing ENTER.
You also have to choose in which direction the pattern should run  (current direction
o
is flashing) choose "left" or "right" and confirm with ENTER.
o Hold mode: 8 built-in full color patterns
Just choose the desired color and confirm with ENTER.
o
JB SYSTEMS
®
OPERATION MANUAL
4/26 LED PIPE CONTROLLER