Specific Safety Rules - Siefken GD1020 Instrucciones De Uso

Pulidora angular de 4 - 1/2” - 115mm
Ocultar thumbs Ver también para GD1020:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3 YEARS
L I M I T E D WA R R A N T Y
SERVICE
• Have your power tool serviced by a quali ed repair person using only identical replacement
parts. This will ensure that the safety of the power tool is maintained.

SPECIFIC SAFETY RULES

Safety Warnings Common for Grinding, Sanding, Wire Brushing or Abrasive Cutting-O Opera-
tions:
• This power tool is intended to function as a grinder, sander, wire brush or cut-o tool. Read all
safety warnings, instructions, illustrations and speci cations provided with this power tool.
Failure to follow all instructions listed below may result in electric shock, re and/or serious
injury.
• Operations such as polishing are not recommended to be performed with this power tool.
Operations for which the power tool was not designed may create a hazard and cause personal
injury.
• Do not use accessories which are not speci cally designed and recommended by the tool ma-
nufacturer. Just because the accessory can be attached to your power tool does not ensure safe
operation.
• The rated speed of the accessory must be at least equal to the maximum speed marked on the
power tool. Accessories running faster than their rated speed can break and y apart.
• The outside diameter and the thickness of your accessory must be within the capacity rating
of
your power tool. Incorrectly sized accessories cannot be adequately guarded or controlled.
• The arbour size of wheels, anges, backing pads or any other accessory must properly t the
spindle of the power tool. Accessories with arbour holes that do not match the mounting hard-
ware of the power tool will run out of balance, vibrate excessively and may cause loss of control.
• Do not use a damaged accessory. Before each use inspect accessories such as abrasive wheels
for chips and cracks, backing pad for cracks, tear or excess wear, and the wire brush for loose or
cracked wires. If power tool or accessory is dropped, inspect for damage or install an undama-
ged accessory. After inspecting and installing an accessory, position yourself and bystanders
away from the plane of the rotating accessory and run the power tool at maximum no-load
speed for one minute. Damaged accessories will normally break apart during this test time.
• Wear personal protective equipment. Depending on application, use face shield, safety gog-
gles or safety glasses. As appropriate, wear dust mask, hearing protectors, gloves and work
shop apron capable of stopping small abrasive or workpiece fragments. The eye protection
must be capable of stopping ying debris generated by various operations. The dust mask or
respirator must be capable of ltrating particles generated by your operation. Prolonged expo-
sure to high intensity noise may cause hearing loss.
4

Publicidad

Tabla de contenido
loading

Tabla de contenido