Care And Maintenance - Siefken GD1020 Instrucciones De Uso

3 YEARS
L I M I T E D WA R R A N T Y
Sanding
Hold tool at 5° to 15° angle to ensure proper sanding pressure and control. Too great an angle will
result in too much pressure and could cause excessive wear to the disc and workpiece. Too small an
angle will reduce control. Use long, sweeping, side-to-side strokes, advancing forward to produce the
desired nish.
Cross Sanding
When nishing a surface that has been prepared by a coarse disc or wheel, sand at right angles to the
strokes made by the coarser disc. Finishing marks left from previous sanding are easily seen and
removed for a uniform nish. Failure to cross sand when changing from a coarse disc to a nishing
disc may result in deep scratches and circular marks.
Removing Welds or Hammer Marks
When removing welds or hammer marks, limit coarse sanding to the immediate area. Use successi-
vely ner grits to smooth surface.
Finishing Metal
Constantly move across the surface. Work faster on curved surfaces where contact areas are smaller
and pressure is greater. Flat areas may appear at the end of the stroke when pressure is too heavy.
Ease up on pressure at end of each stroke and when reversing strokes.

CARE AND MAINTENANCE

WARNING: To reduce the risk of injury, always unplug your tool before performing any maintenance.
Never disassemble the tool or try to do any rewiring on the tool's electrical system. Contact a service
facility or consult the customer service Siefken for ALL repairs.
18