Sunbeam DELUXE MIXMASTER 2356 Manual De Instrucciones página 9

CARING FOR YOUR MIXER
E B D
JECTING THE EATERS OR OUGH
After you've finished mixing, turn the
®
Mix-Finder dial to OFF and unplug the
electric cord from the electrical outlet.
Push the ejector button located near
the handle to remove beaters or
dough hooks.
Scrape excess batter off the beaters
using a rubber or plastic spatula. Do not
strike beaters on the rim of the bowl.
C Y M
LEANING OUR IXER
To clean the mixer, wipe the mixer head,
stand, and turntable with a damp cloth,
then dry. DO NOT IMMERSE THE
MIXER HEAD OR STAND IN WATER.
Avoid the use of abrasive cleaners, as
they may mar the finish of the mixer.
Wash the beaters and bowls in hot,
soapy water after each use. Rinse
thoroughly and dry. Beaters and
bowls may also be washed in an
automatic dishwasher.
C C W
ARE AND LEANING OF THE
(For models with worklight feature only.).
The worklight bulb should be replaced
as soon as it burns out. You may also
wish to remove the worklight lens
periodically for cleaning.
To remove the worklight lens, place
the Mix-Finder
and unplug mixer from electrical outlet.
H
OOKS
Remove beaters or dough hooks
from mixer sockets and remove
bowl from turntable.
Holding the mixer head in an upright
position, use a small screwdriver to
remove the screw holding the
worklight lens in place.
Squeeze the worklight lens, as shown,
until the tabs on the lens clear the
housing. Tilt the worklight lens down
and out of the housing.
To clean the worklight lens, wash in
warm, soapy water. Rinse and dry
thoroughly.
To replace the worklight bulb, unscrew
ORKLIGHT
from socket. Replace with new bulb.
8
®
dial in the ZERO position