SyMBOLS
• The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V ..................volts
Hz ................hertz
min ..............minutes
or DC ...direct current
................Class I Construction
(grounded)
................Class II Construction
(double insulated)
............Read instruction manual before use
................Use proper eye protection
................Use proper hearing protection
................Use proper respiratory protection
fUNCTIONAL DeSCRIPTION
1. On/off switch
2. Lock off button
3. Auxiliary handle
4. Spindle lock
5. Guard
ASSeMBLy
WARNINg
: To prevent accidental operation, turn off and unplug tool before
performing the following operations. Failure to do this could result in serious personal injury.
AUxILIARy hANDLe
WARNINg
: This handle SHOULD BE USED AT ALL TIMES to maintain complete
control of the tool.
An auxiliary 3 position handle is furnished with your grinder. It can be screwed into
either side or the top of the gear case housing.
fitting and removing the guard (fig. A)
The tool is supplied with a guard intended for grinding purposes only. If the unit is
intended to perform cutting off operations, a guard specific
for this operation must be fitted. A suitable guard for cutting
off operations part number 1004484-02 is available and can
be obtained from Black & Decker service centers.
fitting
CAUTION:
the latch in the open position. Undetectable damage to the
guard or the mounting hub may result.
CAUTION:
guard latch, do not use the tool and take the tool and guard
to a service center to repair or replace the guard.
Do not tighten the adjusting screw with
If the guard cannot be tightened by the
A ...................amperes
W ..................watts
or AC .......alternating current
n ...................rated speed
...............earthing terminal
.................safety alert symbol
.../min or rpm ....revolutions or reciprocation
4
7
per minute
1
2
3
5
A