Filter Installation - RIDGID RV2400HF Montaje

Filter Installation

1. Place the HEPA filter onto the filter
cage until the HEPA filter is snug
against the power head. Be sure the
filter cage's threaded stud protrudes
through the HEPA filter opening.
NOTE: Make sure the gasket on the
HEPA filter and the sealing surface on the
power head are not damaged and are
clean and free of debris
2. Position the filter washer with the
rubber side against the HEPA filter and
then place the filter wing nut onto the
threaded stud of the filter cage.
Hand-tighten the filter nut to secure the
HEPA filter to the power head.
Filter
Wing Nut
WARNING: Do not operate
!
without filter cage and float, as they
prevent liquid from entering the
impeller and damaging the motor.
3. Slide the pre-filter onto the assembled
HEPA filter.
Filter Washer
HEPA
Filter
Lower
End Cap
Filter Cage
Power Head
4. Locate the filter band clamp on the
pre-filter, over the lower end cap, as
shown. Tighten with a screwdriver to
secure.
NOTE: Damage to filter will occur if filter
band clamp is tightened around the filter
screen.
Pre-Filter
Lower End
Cap
HEPA
Filter
Filter Band Clamp
Pre-Filter
Filter Band
Clamp
HEPA
Filter
Power Head
Pre-Filter
Filter Band
Clamp
Power
Head
Setscrew