Black+Decker Li4000 Manual De Instrucciones página 4

Destornillador inalámbrica con sujetador de tornillos retrác
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of
work. To reduce your exposure to these chemicals: work in a well ventilated area, and
work with approved safety equipment, such as those dust masks that are specially
designed to filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling,
and other construction activities. Wear protective clothing and wash exposed
areas with soap and water. Allowing dust to get into your mouth, eyes, or lay on the
skin may promote absorption of harmful chemicals.
WARNING: use of this tool can generate and/or disperse dust, which may cause
serious and permanent respiratory or other injury. Always use NIOSH/OSHA
approved respiratory protection appropriate for the dust exposure. Direct particles
away from face and body.
WARNING: AlWAyS use safety glasses. everyday eye glasses are Not safety
glasses. Also use face or dust mask if cutting operation is dusty. AlWAyS
WeAR ceRtIfIed SAfety eQuIPMeNt:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3)
• ANSI S12.6 (S3.19) hearing protection
• NIOSH/OSHA/MSHA respiratory protection
SyMBolS
The label on your tool may include the following symbols.
V ........................... volts
Hz ......................... hertz
min ........................ minutes
or DC ............ direct current
.......................... Class II Construction
......................... safety alert symbol
.../min .................... revolutions or reciprocations per minute
• When using an extension cord, be sure to use one heavy enough to carry the current
your product will draw. An undersized cord will cause a drop in line voltage resulting
in loss of power and overheating. The following table shows the correct size to use
depending on cord length and nameplate ampere rating. If in doubt, use the next
heavier gauge. The smaller the gauge number, the heavier the cord.
Recommended Minimum Wire Size for extension cords
total length of cord
25 ft.
7.6 m
15.2 m
Wire Size AWG
18
50 ft.
75 ft.
22.9 m
18
16
A ......................... amperes
W ........................ watts
or AC .............alternating
n o ....................... no load speed
........................ earthing terminal
100 ft.
125 ft.
30.5 m
38.1 m
16
14
4
current
150 ft.
175 ft.
45.7 m
53.3 m
14
12

Publicidad

Tabla de contenido
loading

Tabla de contenido