Reelcraft SGA3650 OLP Instrucciones De Operacion Y Lista De Partes página 4

Series S
Operating Instructions and Parts List
Maintenance and repair section
Inserting the locking pin service
tool
In the interest of safety we have designed
and constructed a special service tool, a
locking pin that when inserted through the
outer cases it locks the drum from being
able to rotate when carrying out service
work.
We recommend that this tool be used to
prevent damage to the reel or the service
person.
By simply rotating the drum, pulling the
hose slowly and looking into the service
pinhole shown below you will see the line
up holes; insert the pin right through the
reel so that it protrudes out the opposite
side.
Maintenance procedures
Check for leaks
Like all moving and rotating components
there is a need to make regular
maintenance checks. Some of these checks
are very simplistic and only require a visual
inspection others require service work to be
carried out on items such as seals and
O-rings.
For O-ring and seal servicing refer to
"servicing O rings and seals" further in
your manual.
4
Reelcraft Industries, Inc. • 800-444-3134 or 260-248-8188 • Fax: 260-248-2605
A soapy water test is the most simplistic.
Soapy water brushed around each joint will
soon indicate a leak when bubbles appear.
Service or replace O-rings and seals
As with normal and scheduled maintenance
checks, O-rings and seals will need to be
serviced or replaced from time to time. The
task of replacing the O-rings and seals is
quite simplistic and should only take a few
minutes following the procedure below.
Pull the hose all the way out of the reel and
using the service locking tool described in
"use of service locking tool" fix the service
tool in position. This locks the reel and
makes it safe to carry out repairs.
Note: never open the tension side plate or
adjust tension with the hose fully or
partially extended. All the hose must be
fully wound onto the reel.
Disconnect the inlet supply from the inlet
fitting on the reel. Remove the six self-tap-
ping screws in the inlet side plate. Remove
the side plate and the swivel. At the axle
end of the swivel remove the circlip (snap
ring) and slide the swivel sleeve off the
swivel shaft.
This will expose the O-rings and
seals - remove these with an
appropriate tool.
reelcraft@reelcraft.com • www.reelcraft.com
SGA3650 OLP
SGA3665 OLP
SGA3850 OLP
Note: Do not score or scratch the
O-ring or seal, sealing surfaces.
Replace the O-rings and seals and apply an
appropriate lubricant.
Note: Use only Reelcraft original seals and
O-rings, failure to do so will void warranty.
Re-assemble the swivel and refit in
position, replace the self-tapping screws,
holding the hose. Remove the service tool
and rewind the hose. Reconnect the inlet
supply and check for leaks. Refer to
"checking for leaks" earlier in the manual.
Step 1 Step 2
How to add
or remove tension
Note: Never add or remove tension when
the hose is extended from the reel. The
hose must always be fully wound on the
hose reel.
Add tension-turn clockwise
Remove tension-turn counter clockwise
SWA3850 OLP
SHA3850 OLP
SCA3850 OLP