Reelcraft SGA3650 OLP Instrucciones De Operacion Y Lista De Partes página 6

Series S
Operating Instructions and Parts List
Re-connect the hose to the barb of the
swivel using a suitable clamp. Replace the
swivel and refit the cable tie to hold the
hose to the drum and refit the swivel and
side plate. Reconnect the inlet supply and
check for leaks. Remove the service tool
while holding the main cable or hose and
allow the cable or hose to retract.
Replace the tension locking
system
Note: Never open the tension side plate or
adjust tension with the hose fully or
partially extended. All the hose or cable
must be fully retracted onto the reel
(i.e. fully wound on the drum of the reel)
The first step is to remove tension from the
reel. Using a "C" spanner or the service
tool hold the center locking cap and
remove the four outer screws.
Note: There is tension on this cap and it
will want to spin anticlockwise so hold
tightly.
Once the screws are removed allow the cap
to unwind in a controlled manner, once the
tension is released the cap will sit
stationary. This has now released all the
tension.
Remove the six self-tapping screws holding
the tensions side plate.
Once you have removed the side plate
check to see if there is any damage to the
locking system/ratchet teeth located on the
inner drum.
If the locking teeth/ratchet teeth are
damaged or broken you will need to replace
6
Reelcraft Industries, Inc. • 800-444-3134 or 260-248-8188 • Fax: 260-248-2605
the inner drum spring canister. Refer
"replacing broken spring" section at this
point.
If these are all okay without damage refit
the nw side plate assembly and follow the
procedure for re-tensioning the reel in the
previous section.
To add tension follow the steps above
"Adding tension" if you have removed all
the tension and are re-tensioning add five
full turns to start with and then one more at
a time if necessary. Repeat the steps as
described in "Adding tension."
261908 O-Ring service
kit, (2 O-rings, 2 snap
rings, O-ring lube &
service manual)
261907 Mounting
Bracket
261902 Inlet Side Plate
reelcraft@reelcraft.com • www.reelcraft.com
SGA3650 OLP
SGA3665 OLP
SGA3850 OLP
Parts break down
Typical main assembly
SWA3850 OLP
SHA3850 OLP
SCA3850 OLP
602019 Side
Plate (Comes
assembled as
shown in box)
602018 Hose Guide