Nilox UPS SERVER PRO Manual Para El Usuario página 3

Connect the devices
Plug in the devices to output receptacles on the rear panel of the UPS. Simply turn on the power
switch of UPS unit, then the devices connected to the UPS will be protected by UPS unit.
CAUTION: NEVER connect a laser printer or
scanner to the UPS unit. This may cause the
damage of the unit.
Connect Modem/Phone/Network for surge protection (Only for the model with RJ-11/RJ-45)
Connect a single modem/phone line into surge-protected "IN" outlet on the back panel of the UPS
unit. Connect from "OUT" outlet to the computer with another phone line cable.
Connect communication cable (Only for the model with USB/RS-232 port)
To allow for unattended UPS shutdown/start-up and status monitoring, connect the communication
cable one end to the USB/RS-232 port and the other to the communication port of your PC. The
software is available on our website http://www.nilox.com
Turn On/Off the unit
Turn on the UPS unit by pressing the power switch. Turn off the UPS unit by pressing again the power
switch.
Indicators and alarm table for operation
Condition
AC mode
Battery mode
Low battery (20-30%) at
battery mode
Fault and Overload
AVR working or Over-
temperature protection
alarm (if available)
Visual Indicator
LED On
LED flashing every 5-10 seconds
LED flashing every second
LED On
LED flashing every 0,5 seconds
Alarm
Off
Sounding every 5-10 seconds
Sounding every second
Continuously sounding or
every 0,5 seconds
Off