Cleaning And Disinfecting - FujiFilm SonoSite PowerPack Manual Del Usuario

PowerPack cables and connectors
Cable Connector 1
[Letter] [Illustration]
[Name] [Connects to]
[Illustration]
A
Power-supply
DC power cord
6.8 ft./2 m
PowerPack DC
input port
K
System AC
power cord
10 ft./3 m
Stand
Z Pre-installed
PowerPack DC on PowerPack
power cord
4

Cleaning and disinfecting

Cleaning and disinfecting
Connector 2 WARNING:
[Illustration]
[Connects to]
Pre-installed
on stand
Wall outlet
Caution:
DC input on
mini-dock,
NanoMaxx
dock, or system
To clean and disinfect the PowerPack
You can clean and disinfect the exterior surface of
the PowerPack using a recommended cleaner or
disinfectant. For the most recent list of approved
products, see www.sonosite.com.
1 Unplug the power supply, and detach any cables.
To avoid electrical shock, before
cleaning always disconnect the
system from the power supply and
remove it from the stand.
To avoid injury, always use
protective eyewear and gloves
when performing cleaning and
disinfecting procedures.
To avoid infection, ensure that the
solution expiration date has not
passed.
To avoid infection, the level of
disinfection required for a product
is dictated by the type of tissue it
contacts during use. Ensure that the
solution strength and duration of
contact are appropriate for the
equipment. For information, see the
disinfectant label instructions and
the recommendations of the
Association for Professionals in
Infection Control and Epidemiology
(APIC) and FDA.
Use only recommended cleaners
or disinfectants on surfaces.
Immersion-type disinfectants are
not tested for use on surfaces.
To avoid damaging the battery,
do not allow cleaning solution or
disinfectant to come in contact with
the battery terminals.