Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Master Audio
• High Pass – First adjust the High Pass Filter cut-off frequency. To switch it off, turn
the rotary knob counter-clockwise until frequency reaches 20 Hz.
Second, press the rotary knob and select from the available types and slopes:
Type: Butterworth, Slopes: 6dB, 12dB, 18dB or 24dB
Type: Bessel. Slopes: 6dB, 12dB, 18dB or 24dB
Type: Linkwitz-Riley. Slope: 12dB or 24dB
Out12
HighPass
XOver
Freq:
40Hz
5.2.5 Parametric EQ
Select between one of the 10 available Equalizers on each output channel by using
the keys < Select and Select >. Browse the parameters by turning the rotary knob
and push the knob to select and confirm the values. The following parameters can be
adjusted for each EQ:
• Freq - EQ center frequency.
• Gain - EQ level gain.
Out12
PEQ 1
Freq:
1000Hz
• Q - EQ Bandwidth. For shelving filters the Q sets the transition in dB/Oct.
• Type - Shape of EQ. The available types are:
Bell: Modifies the gain of a certain frequency range, with bell shape
Notch: Eliminates a range around a center frequency
Low-Shelf: Modifies the gain of all the range below a selected frequency.
High-Shelf: Modifies the gain of all the range above a selected frequency.
All Pass: Modifies the phase response, without influencing the frequency response.
Band Pass: Filters out all the range except the defined band.
High Pass: Filters out all the range below a certain frequency.
Low Pass: Filters out all the range above a certain frequency.
Out12 PEQ 1
Q:
2.36
• Enabled – When set On, the currently selected EQ is on line.
Out12 PEQ 1
Enabled: On
DSP206-608. Version 1.2
Out12
HighPass
XOver
Type:
BUT 24dB
Out12
PEQ 1
Gain:
0.00dB
Out12 PEQ 1
Type: Bell
Apr 14
14
Publicidad
Tabla de contenido
