Before You Start - Master audio DSP206 Manual Usuario

Master Audio
DSP608 only
E) Ethernet port – RJ45 connector to connect with the PC via Ethernet. Use CAT-5
or CAT-6 cable.
F) AES/EBU Input – This XLR connector accepts a 2-channel digital input in
AES/EBU or S/PDIF format, 16 or 24-bit. Supported sample rates are 44.1, 48,
88.2 and 96 kHz.
4 QUICK INSTALLATION

4.1 Before you start

Before powering up the unit, make sure that the input and output XLR cables are in
good state and following the following pinning diagram: 1 for shield, 2 for live(+), 3 for
return (-) as defined by the AES14 standard.
Do not connect the unit to your computer before installing the software and the USB
Driver. Please refer to installation instructions in this manual.
When connecting the DSP to the amplifiers, mute the DSP outputs (or turn down the
amplifier's volume knobs) until you configure your processing. Loudspeakers may be
damaged due to a wrong setup. It is advisable to unmute first the high frequency
channels: in case they are connected to low frequency drivers by mistake, they
cannot be damaged. Otherwise, high frequency speakers may be damaged because
of trying to reproduce low frequencies.
4.2 Power Up
After powering up the unit, all LEDs will be lit for about six seconds, while the
following message is displayed on the LCD:
Initialising...
After that, the DSP unit displays its main screen:
MASTER AUDIO
DEFAULT PRESET
Now the DSP unit is ready to operate. The screen shows the name of the unit (above
line) and the program name currently active (below line). The program assigned is
always the last program the user recalled or stored before powering down the unit.
An admiration mark (!) beside the program name means that the program has been
modified but not stored. This symbol does not appear when the modified program is
the default preset.
MASTER AUDIO
! My_Preset
DSP206-608. Version 1.2 Apr 14 7