Publicidad
Step 2
Fasten the CABINET RIGHT (5) to the LEFT UPRIGHT LEG (B). Use three BLACK 1/2" FLAT HEAD SCREWS (19).
å
Fasten the CABINET LEFT (6) to the LEFT END LEG (A). Use three BLACK 1/2" FLAT HEAD SCREWS (19).
å
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the upper diagram below. Be
å
prepared, the parts are greasy.
Fasten the EXTENSION RAILS (1) to the LEFT END LEG (A) and LEFT UPRIGHT LEG (B). Use six BLACK 1/2" FLAT
å
HEAD SCREWS (19).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other holes that line up with the holes in the LEFT LEGS. Turn a
SCREW into those holes.
NOTE: The EXTENSION SLIDES will be used later for the LARGE DRAWER.
å
2
Push the black lever in and pull the SLIDE from the RAIL.
Roller end
6
A
Open end
1
5
B
1
Open end
BLACK 1/2" FLAT HEAD SCREW
1
Roller end
19
(12 used in this step)
Page 7
Publicidad
