Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
4
Soap Dispenser Installation
Separate head (1) from body assembly
(2). Make sure gasket (3) is properly
seated in the base of the body assembly.
Insert body assembly through selected
hole in sink. From under the sink secure
body assembly to sink with nut (4). Screw
the bottle (5) onto the body assembly
shank. Insert pump (6) down into the
body assembly, then attach head
assembly (1) to pump.
1
6
2
3
4
5
Note: To fill, lift the head and pump
assembly out of the bottle and pour
not more than 8 oz. into bottle. DO
NOT remove the bottle each time as
this weakens the neck. Use a funnel to
help prevent spills. Pull pump and head
assembly out occasionally to soak and
pump warm water through pump to
remove soap build-up.
7
Publicidad
Tabla de contenido
