Using The Device - camry Premium CR 7810 Manual De Uso

sink filled with water.
15. The heater should be placed on a level, heat-resistant surface, away (at least one
meter) from flammable materials (lace curtains, curtains, wallpaper, furniture etc.).
16. The power cable should not be placed above the heater, and also should not touch or
lie close to hot surfaces. Do not place the heater under an electrical outlet.
17. The surface of the heater can heat up to high temperatures of over 60 degrees C. Take
care when near the heater.
18. Do not cover the heater with curtains, a towel or hang washing on it – this can damage
the heater or cause a fire.
19. When using the heater, completely unwind its cable and make sure that the cable is not
touching the hot surface of the heater.
20. Do not use the heater near basins, showers, sinks, pools or other places where it can
get wet.
21. The device must be completely cool prior to storage. Keep the original packaging to
store the heater in during non-heating seasons.
22. The heater is filled with a set amount of special oil. Repairs requiring opening of the oil
container must be carried out only by the manufacturer or authorized representative, who
should be contacted if oil leaks from the heater.
23. If disposing of the heater please follow rules of oil disposal.
WARNING: To avoid overheating do not cover the heater.
DESCRIPTION OF THE DEVICE (Figure 1)
1.Carry handle 2..Safety power switch
A.– low power level 800W indicator
C.– high power level 2000W indicator
E.– timer mode indicator
4.Control panel:
G.– power button
I.– temperature increase button
K.– timer switch
5.Cord storage 6.Radiant ribs
ASSEMBLY (Fig. 2)
1. Turn the heater upside down.
2. Place the wheel bases between the first two ribs and end two ribs.
3. Use the U-shaped clamp to hook the bases.
4. Block the clamp by screwing on the butterfly nut.
5. Place the heater on the wheels.
CAUTION: After turning the heater, wait at least one hour before connecting it to a power outlet.

USING THE DEVICE

CAUTION: During first use of the heater a small amount of smoke may appear. This is normal.
1. Place the oil heater a minimum of 100 cm from walls, furniture, curtains, plants etc. on a flat and stable surface.
2. Make sure that all controls are set to off position. Connect the oil heater to mains power, press the power switch on (2) and then
press power on button (G) to start operation, press both again to stop operation. To turn off the device, press the power button (G) and
then press the power switch (2).
3. Power level setting
After power on the device press mode switch (H) on the control panel (4) to select desired power level 800W or 1200W or 2000W by
repeated pressing. The display (3) will light up indicator A or B or C.
4. Temperature setting
3.Display:
B.– medium power level 1200W indicator
D.– heating mode indicator
F.– power indicator
H.– mode switch to select power level 800W / 1200W / 2000W
J.– temperature decrease button
7.Wheels 8.Remote control
6