Philips SBC RU 220/00 Instrucciones De Manejo página 6

RU220- page 6
SBC RU 220
READING OUT THE 3-DIGIT BRAND CODE
After using autosearch to set up the SBC RU 220, note the 3-digit code for
future use.
1. Press the button of the device [TV or VCR] you want to read the code from.
2. Press and hold 1 and 6 at the same time for 3 seconds.
– The indicator LED lights up.
3. Press -/--;
– The LED indicator goes out.
4. Press 1:
– the indicator starts to blink; Count the number of blinks for the first digit.
Note: if the indicator does not blink, the digit is 0.
5. Press 2:
– the indicator starts to blink; Count the number of blinks for the second
digit.
6. Press 3:
– the indicator starts to blink; Count the number of blinks for the third digit.
7. Write down the code inside the SBC RU 220's battery lid.
FREE-PHONE HELP-LINE
If you have any problems with your Philips Universal remote control, please ring
our free-phone help-line.
United Kingdom: 0800-968-118
Ireland: 1-800-533-136
Before calling, note the data of your equipment in the table below.
This makes it easier and faster for us to help you.
Type-numbers can usually be found in the original manual, or on the factory
plate on the back of the equipment.
Device Brand
TV
VCR
6
Instructions for use
Model nr. RC model nr. Used code