Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
SIMPLIFIED PROGRAMMING
The door unit and the door phones can be programmed without external devices in 2nd edition systems
consisting of main calling stations only (up to three). The following parameters can be programmed in this
case:
•
Main station number: with dip-switch (1,2,3);
•
Lock activation time: with LED button (1-30s);
•
Door phone programming with LED button (predetermined user codes).
Station number (ID)
The two dip-switches determine the main station number as shown in the following table:
Dip-switch
Main station number
position
ON
ON
Not defined (for programming
with an external keyboard)
1 2
1 2
ON
Station
1 2
Electrical lock time
Press the programming button (3) and wait for the respective LED to come on.
Beeps will be repeatedly generated if there are other stations with the same ID. Press the button again to
quit the operation, correct the mistake with the dip-switches and repeat the operation.
Hold the "hall" button pressed for the time to be programmed (up to 30 s). The door unit will acquire the
value and a confirmation beep will be heard. Press the programming button to return to normal operation.
Door phone programming
The door unit is programmed by default at the factory.
Consequently, the code-button association phase can be skipped in systems without secondary units. In
this case, go to the door phone programming procedure directly. The procedure consists of two steps:
A.
Door phone booking (to be made on a calling station).
B.
Door phone programming.
A: Door phone booking (to be made on a calling station)
1.
Press the programming button and wait for the respective LED to come on. Press the user buttons to
be associated with the door phones once. The booking sequence according to which the buttons are
pressed must be the same as the order in which the operator will go to the apartments.
.
DO NOT press the switchboard call button.
B: Door phone programming
1.
Wait for 30s until the LED starts blinking.
.
Go to the first booked user, hold the button pressed and lift the door phone handset. Two confirmation
beeps will be heard and the LED will flash to indicate that it has been programmed.
3.
Go to the other booked users and repeat the operations.
Refer to the attached sheet to remember the code/button association sequence.
IMPORTANT: The LED will start blinking if the buttons are not booked and no operation is carried out
for 30 seconds during the programming procedure. In this case, press the programming button to quit
DS107-034
SEQUENZA DI ASSOCIAZIONE
ASSOCIATION SEQUENCE
N° DELLA POSTAZIONE (ID):
CALL MODULE NUMBER (ID):
SEQ.
NOMINATIVO
PULSANTE / CODICE
USER NAME
PUSHBUTTON / CODE
1
2
3
Dip-switch
Main station number
position
ON
Station 1 (default)
1 2
ON
Station 3
1 2
PIANO
VARIE
FLOOR
VARIOUS
19
Publicidad
Tabla de contenido
