Klimatronic Transform Serie Manual De Instrucciones página 16

BEFORE INITIATION
1. To avoid damage, place the TRANSFORM unit in an upright position for at least 24 hours before
initiation.
2. Release the holder air hose in the TRANSFORM unit and take out the extract air hose.
3. Fasten the air hose before initiating the TRANSFORM unit.
4. Turn the extract air hose in the direction of the arrow (1) displayed and remove it from the
TRANSFORM unit.
5. Turn the extract air hose in the direction of the arrow (2) displayed and connect it to the
TRANSFORM unit.
6. Plug the power plug into a socket. Never pull the plug out of the socket with force using the
connection line. This can damage the power cable.
7. Since the TRANSFORM unit emits hot air, please observe a sufficient minimum safety distance to
each wall. (Fig. 1)
8. Despite the splash water protection, you should not operate the TRANSFORM unit in moist areas,
such as e.g. swimming baths or similar areas.
9. The colour of the TRANSFORM unit can change slightly due to direct solar radiation.
10. The TRANSFORM unit is equipped with a special thermal deactivation. This protects the unit from
overheating in extreme ambient conditions.
11. Please place the TRANSFORM unit so that the air inlet is not impeded, e.g. by furniture or curtains,
since this can negatively effect the capacity.
12. Do not allow direct sunlight to shine on the TRANSFORM unit, since it may then overheat and
automatically deactivate on account of the thermal deactivation.
NAME OF THE COMPONENTS
1. Operating panel
2. Control lamp
3. Air outlet grid
4. Wall adapter
5. Air hose
6. Upper condensation water outlet with rubber plug
7. Carrier handles
8. Air hose connection piece
9. Activated carbon filter top
10. Coarse filter top
11. Filter grid
12. Coarse filter bottom
13. Lower condensation water outlet with rubber plug
16