en
EnGLISH
1 - INStAllAtIoN PReCAUtIoNS
IMPORTANT: Read this instruction manual carefully before
placing this device.
1.1 - General
•
If these installation instructions are not observed. the
f these installation instructions are not observed. the
manufacturer declines all responsibility and any warranty
will become invalid.
•
For a problem-free installation it is important to choose a
qualified installer and to follow the operation sequence in
the introduction.
•
Inspect the device upon receipt in order to check for
possible damage caused during transport or by incorrect
handling. If damage is found, immediately file a claim with
the transport company.
1.2 - Protection against electrocution
•
The power must be disconnected before connecting the
device.
•
Observe all applicable national safety standards.
1.3 - General installation requirements
•
after the installation, carry out a complete system check
and explain all system functions to the user.
•
Leave this manual with the user for his reference during
future maintenance operations.
•
In case of a fault, switch the device off, disconnect it from all
power supplies and call the after-sales service.
•
Dispose of the packaging materials in accordance with local
regulations.
En-4
minimum clearances, mm
the
ATTENTION
- Place the simplified wall thermostat (SUI) in a position
where the room temperature is typical.
- Do not damage the temperature sensor under the box.
- The wall support is attached with four screws.
The wiring must comply with professional standards and with
all applicable regulations:
•
Ensure that the polarity of the connections is correct.
•
Be careful with the connection cable shielding.
•
Ensure that high-voltage cables are not transposed.
ATTENTION
- Do not position this device on a section of the wall that
contains pipes or cables.
- Avoid heat sources, air currents, direct sun-light and badly
ventilated locations.
Recommended
Forbidden
En-4