Husky 27BC401BP-THD Guia De Inicio Rapido página 4

INSTALLING DRAWERS
Ball bearing slide - Pull slides and slide carrier out to fully
extended position (see illustration.) Hold the slide on the
cabinet while aligning it with the slide on drawer. Slightly
insert one side and repeat for the other side. Slowly push
drawer to its fully closed position to engage slide. Open
drawer and reclose to ensure proper operation.
slide carrier
slide
REMOVING AND INSTALLING SLIDES FROM UNIT
• First remove the drawer. (See section A)
To remove the slide
• Push slide to the closed position.
• Insert flat tip screw driver between slide and unit,
behind rear rectangular cutout.(See illustration.)
• Rotate screw driver 1/4 turn to force slide away
from unit.
• Push on front of slide pushing it towards back
of the unit.
To attach the slide:
• Extend slide and locate lances within respective
cutout in carrier.
• Pull slide forward until slide locks back into place.
• Reinstall drawer following drawer installation
procedure.(See section B)
Leveling Foot Adjustment
• Adjust Screw Leveler to desired position with Flathead
Screwdriver or 7/16in open end wrench as shown.
LOCKING AND UNLOCKING THE UNIT
Locking the Unit:
• Make sure drawers are fully closed.
• Insert the key and turn fully to the left.
• Remove key.
Unlocking the Unit:
• Insert the key and turn fully to the right.
• Remove key.
4