Bestway Ramble X2 Manual Del Propietário página 2

INTRODUCTION
Proper Use
Any use other than that described or any
modification of the product is not permissible and
may result in injury and/or damage to the product.
The manufacturer is not liable for damage caused
by improper use. The product is not intended for
commercial use.
Description of parts and features
A
Tent Pole
1PC 1PC
D
Peg Carry bag
4PCS 1PC
Tent Dimensions:
Outer tent: 200cm x 100cm x 120cm
Pitching dimension: 210cm x 110cm
WARNING
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
Keep all flames and heat sources away from this
tent fabric. We recommend that you always
position your tent upwind from a camp fire. This
will reduce the chances of having embers land on
your tent. In case of fire, please find the exit to
escape from the fire.
Never set up the tent near the river, under the tree
of other objective hazards.
Keep exits clear.
Make sure ventilation openings are open all the
time to avoid suffocation.
SAVE THESE INSTRUCTIONS
ASSEMBLY
Setting up the tent
B1
B2
FIG1
Ower's Mannal
Model No.#68001
Ramble X2 Tent
B1 B2
Pole
2PCS
Bestway
F G
Manual
1PC
FIG2
D
1. Lay the tent<A> on the ground. Pull the four
corners outwards.
Note: Make sure that the channels for the
poles<B1> are facing upwards.
Note: Make sure that the zip on the entrance to
the tent is closed.
2. Push the pole<B1> completely into the
channel. (FIG1)
3. Stand the inner tent<A> up and push the ends
of the poles<B1> into the ground sleeves (which
are on the each corner of the inner tent<E>).
(FIG2)
4. Push the poles<B2> into the channels and push
the two ends into the ground sleeves. Then
push another ends into the loops at the top of
the tent. (FIG3)
5. Secure the tent by pushing the tent pegs<D>
into the ground loops. (FIG3)
DISASSEMBLE AND MAINTENANCE
Follow steps 1-5 in reverse order.
1. Clean the tent and remove any stains with
sponge and cool water. Please use
non-detergent soap for serious cleaning.
2. Never machine wash or machine dry the tent.
Hand wash and air dry.
3. Please allow all parts to dry thoroughly before
you repack the tent. This will prevent the
formation from mould, bad odours and
discolouration.
4. Stitch with thread to repair minor leaks, fabrics
and plastic sheets damage. Use ropes to
connect broken frame parts. Use tapes to repair
the coating broken parts.
5. Silicone spray could be use onto zippers if stick.
STORAGE
Store the tent in the stuff sack and place it in a
cool, dry area out of sunlight and away from heat
sources and rodents.
2
FIG3
S-S-002060