Atlas Copco G2420 Manual De Producto página 15

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 64
G2420
4. Adjust the rotor (25), it shall lightly touch the front end plate (26) and be
possible to rotate.
5. Attach the rotor blades (24) on the rotor (25).
6. Make sure that the o-ring (22) is attached in the cylinder (23).
7. Push the cylinder (23) on the rotor (25).
8. Push the ball bearing (20) into the rear plate (21).
9. Push the assembled ball bearing (20) and rear plate (21) on the rotor (25)
so that the rotor lightly rotates and the cylinder is supported correctly.
Assembling the motor housing
1. Attach the o-rings (10/11) to the valve body (12).
2. Attach the o-ring (8) to the valve stem (9).
3. Attach the valve spring (7) to the assembled o-ring (8), valve stem (9) and
push them into the motor housing (1).
4. Put the valve body (12) with the o-rings (10/11) on the valve stem (9) and
tighten.
5. Fasten the screen (4) to the adaptor (3) with the retainer (5).
6. Put the assembled motor into the motor housing of the grip cover (1).
EN
© Atlas Copco Industrial Technique AB - 9839 0458 00
Service
15

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

8423030420

Tabla de contenido