LEITZ TruSens Z-1000 Manual De Instrucciones página 12

REPLACING
1. The Carbon indicator will glow red when it is time to replace
the Carbon layer.
2. Gently peel away the used Carbon layer from the fastener
strips (Fig. E).
3. Wrap a new Carbon layer around the filter drum and attach
to the same fastener strips (Fig. F).
4. Once the purifier is powered-on, hold the Reset button until
the red Carbon indicator turns off.
Note: Carbon Prefilter 3-pack (on page 10) will cover 3 Carbon
changes between replacing the entire HEPA drum filter assemly
(on page 11).
12
CARBON PREFILTER
Fig. E
Fig. F