ANATEL MiBox UNICORN Guía De Configuración Rápida página 3




"LAN" Port: Used to connect the LAN cable to the MiBox for wired network
connection.

"5VDC 1.5A" Port: For scanner without a 24VDC power jack, use this port to
connect the box to a USB power adapter via a Micro USB cable.

"24VDC IN" Port: Used to connect the power adapter that comes with the
scanner to the MiBox.

"WPS" Button: Press to use WPS (Wi-Fi Protected Setup
access point which supports WPS. Press the WPS button of your Access
Point, and then press and hold the WPS button of MiBox for 5 seconds until the
Status LED flashes in red to start the WPS connection.

"Reset" Button: Restore the network security settings to factory default. To
reset the MiBox, use a pen to press and hold this button for about 5 seconds
until the blue network LED turns off. Wait for about 30 seconds until the blue
Network LED turns on and starts blinking again.



TM
) to connect to an
3