Fitting Instructions - HoMedics THERA-P MW-NHC-EU Manual Del Usuario

MW-NHC-EU_IB_Layout 1 12/01/2011 16:46 Page 6
Microwave
DO NOT PLACE GEL INSERT DIRECTLY IN MICROWAVE.
1. Heat water in microwaveable container on high setting for 3 minutes. This
is based on a 600 watt microwave. Use a minimum of 450ml of water.
Heating times may vary. Follow all precautions and recommendations
found in your microwave oven instruction manual with respect to the
heating of water. Do not insert gel pack directly into microwave as this
may cause damage to the seal. After heating, let water stand in microwave
for thirty seconds before moving it or inserting the gel pack.
2. Place gel insert in hot water for 1 minute.
3. Remove insert using tongs. Use caution as the insert will be very hot.
4. Test temperature of insert by placing it on the underside of your wrist. If
insert is too hot, allow it to cool before using. If it is not hot enough,
continue heating in 1 minute intervals until desired temperature is reached.
5. Place gel insert into pocket of wrap.

Fitting Instructions

1. Position wrap around neck as desired. Inside of wrap should face skin.
2. Secure wrap using fastening tab, readjusting until comfortable. Do not
secure wrap too tightly, as it may restrict blood circulation.
6