Maintenance; Troubleshooting - Extel WEVPMH 001 Instrucciones De Uso

14

MAINTENANCE

The warranty is void if the parts are dismantled. Clean the outside only with a soft and dry cloth. Before cleaning, disconnect
and switch off the video surveillance system.
CAUTION: Do not use any acid or alcohol based or other similar cleaning product or solvent. You may damage the ap-
pliance and the vapours are explosive and dangerous for your health.
Do not use any tool which can be voltage conductor (metallic brush, sharp tool...or other) for cleaning.
15

TROUBLESHOOTING

With this video surveillance system, you have bought a high technology and ready to use product.
All parts are supplied to use completely your kit.
Nevertheless if you encounter problems or dysfunctions, you can remedy these defects by reading the following table:
Failure
The system does not turn on
- red led turned off
- green led turned off
No link between panel and monitors
...or a single monitor
One of the monitors does not ring, a
message «do not disturb» displays.
Problem of video quality
Sound too loud/soft on the panel or
all the monitors
Sound too loud/soft on a single mo-
nitor
The conversation, viewing times are
too short/long
The strike control is to short
The electric strike does not work
monitor
18GB
Cause
Power supply problem
Wiring problem
Wiring problem
«Do not disturb» mode
active
Settings
Settings
Settings
Settings
Settings
Wiring problem
The presence of an add.
monitor is not indicated
on the roadside panel
CFI EXTEL WEVPMH 001 - 03/2010 - V1
Solution
- Check the connection on 230VAC
- Check the position of the switch 3
- Check wiring of P- P+ wires
- Check wiring and specially RJ45 cords, if you have
mounted them
- Check the correct input is used on the distributor
- Check the monitor or all the monitors are pro-
perly paired Chap 6 and 7
Chapter 10 «mute function»
Check the position of the switch on the
distributor,Reminder: the switch must be in HI posi-
tion on the last distributor only
Chapter 8 -b menu #9008
Chapter 10 - settings monitor
C
timing
Check the connection. Caution, do not confuse ins-
tallation of a current-controlled strike with a current
cut-off controlled strike, chapter 5b
Chapter 11, parameterization to perform or chapter
9 «option management»