Wireless Configuration - Juniper Networks NetScreen-5GT Wireless Manual Del Usuario

W C
IRELESS ONFIGURATION
This section provides information for configuring the wireless interface on the NetScreen
device. Depending on the type of license you have installed, you can configure up to four
wireless security zones on a NetScreen-5GT Wireless device. The interface to zone
bindings are predefined and are dependent on the port mode you configure, and you
cannot assign wireless interfaces to the Untrust zone. You must configure at least one
wireless interface on the NetScreen device to create a wireless local area network
(WLAN).
Note: If you are operating the NetScreen-5GT Wireless device in a country other than the
United States or Japan, then you must use the set wlan country-code command before a
WLAN connection can be established. This command sets the selectable channel range
and transmit power level.
The figure below shows the default configuration for the NetScreen-5GT Wireless device.
External router,
switch, or hub
The default wireless interface has the predefined name "wireless2". The Trust and
wireless2 interfaces are bound to the Trust zone and are configured with the subnetwork
addresses 192.168.1.1/24 and 192.168.2.1/24, respectively. This means that all devices
that you connect to in the Trust zone must be in the same subnetwork as either the Trust
or wireless2 interface and have IP addresses in one of the two subnetworks. The
NetScreen device is also configured to assign IP addresses for the 192.168.1.1/24 and
192.168.2.1/24 subnetworks to your devices. For more information, refer to
Trust or Wireless2 Interface Address" on page
NetScreen-5GT Wireless
To Internet
wireless1 Interface
wireless2 Interface
192.168.2.1/24
Trust Interface
192.168.1.1/24
Hub
Trust Zone

Wireless Configuration

Wzone1 Zone
29.
"Changing the
17