Features; Installation; Cable Installation; Package Contents - LEGRAND C2G C2G30018 Manual Del Usuario

Dual 4K HDMI® HDBaseT + VGA , 3.5mm, and RS232 over Cat Switching
Extender Box Transmitter - 4K 60Hz

Features

3x1 UHD digital AV switcher and transmitter.
•
Transmitter consists of two HDMI inputs, one VGA with analog audio embedding.
•
Extend 4Kx2K at 60Hz (4:2:0) up to 130ft and 1080p at 60Hz up to 230ft with Cat 6a/7 cable.
•
Extend 4Kx2K at 60Hz (4:2:0) up to 115ft and 1080p at 60Hz up to 200ft with Cat 5e/6 cable.
•
HDMI 1.4 with 4K at 60Hz, 4:2:0, 8bit and HDCP 2.2 compliant.
•
VGA up to 1920x1200 at 60Hz.
•
HDMI input EDIDs are copied from HDBaseT receiver but are limited below 4K30. VGA input
•
EDID is fixed at 1080p 60Hz. All HDMI and VGA EDIDs can be configured by API CMD.
All input sources audio EDIDs are fixed at PCM 2CH.
•
Control and configure both local and remote devices via RS232.
•
Automatic CEC command to Power on/off display device, by detecting input signal status.
•
Bi-directional Power over Cable (PoC), when transmitter or receiver is plugged in to power,
•
both sides are powered on.
Mounting Bracket Installation
Note: Before installation, please ensure the unit is disconnected from the power source.
1. Remove the screws on one side of the enclosure.
2. Attach the installation bracket to the enclosure of transmitter using the screws provided in the package.
3. The bracket is attached to the enclosure as shown.
4. Repeat steps 1-2 for the other side of the unit.
5. Attach the brackets to the surface you want to mount to using screws (not included).

Cable Installation

Note: Before installing cables, please ensure the unit is disconnected from the power source.
1. Connect Dual HDMI IN: Connect up to two HDMI source devices (e.g. Laptop, Blu-ray player, etc.) to HDMI IN 1 and HDMI IN 2 of the transmitter
using a high-quality HDMI cable.
2. Connect VGA IN: Connect a VGA source device (e.g. Laptop, desktop, etc.) to VGA IN of the transmitter using a VGA cable.
3. Connect AUDIO IN: Embedding for VGA IN.
4. Connect HDBT: Connect HDBT Out of the transmitter to the HDBT IN of the receiver using a Cat 5e/6/6a cable.
5. Power on all attached devices.

Package Contents

•
•
•
•
•
3
1 x Transmitter
1 x 18V Lock Power Adapter
1 x 3-Pin Phoenix Male Connector
2 x Mounting Bracket (with screws)
1 x Manual
(us) (us)
(us)